"Статус инициализации четности: выполняется" в течение длительного времени

Две недели назад я установил 6 новых жестких дисков (HP 500 ГБ, 6 ГБ, 7,2 КБ, 2,5-дюймовый, 2-портовый, SAS DualPort Midline, 507610-B21) в "HP DL 380 G5" с "Smart Array P400" (версия встроенного ПО RAM 2.08, ROM Firmware Revision 2.08).

Я создал новый логический диск с 5 физическими дисками в RAID 5 и запасным диском (массив B):

[...] => ctrl all show config

Smart Array P400 в слоте 1 (sn: P61620D9SUKHBP)

массив A (SAS, неиспользуемое пространство: 0 МБ)

  logicaldrive 1 (136.7 GB, RAID 1, OK)

  physicaldrive 2I:1:1 (port 2I:box 1:bay 1, SAS, 146 GB, OK)
  physicaldrive 2I:1:2 (port 2I:box 1:bay 2, SAS, 146 GB, OK)

массив B (SAS, неиспользуемое пространство: 0 МБ)

  logicaldrive 2 (1.8 TB, RAID 5, OK)

  physicaldrive 1I:1:5 (port 1I:box 1:bay 5, SAS, 500 GB, OK)
  physicaldrive 1I:1:6 (port 1I:box 1:bay 6, SAS, 500 GB, OK)
  physicaldrive 1I:1:7 (port 1I:box 1:bay 7, SAS, 500 GB, OK)
  physicaldrive 2I:1:3 (port 2I:box 1:bay 3, SAS, 500 GB, OK)
  physicaldrive 2I:1:4 (port 2I:box 1:bay 4, SAS, 500 GB, OK)
  physicaldrive 1I:1:8 (port 1I:box 1:bay 8, SAS, 500 GB, OK, spare)

[...]

After that I could create the filesystem on It, mount It and use It without any issue.

My problem is that One week later the controller still was initializing parity.

[...] Массив: B Тип интерфейса: SAS Неиспользуемое пространство: 0 МБ Статус: ОК

  Logical Drive: 2
     Size: 1.8 TB
     Fault Tolerance: RAID 5
     Heads: 255
     Sectors Per Track: 32
     Cylinders: 65535
     Stripe Size: 64 KB
     Status: OK
     Array Accelerator: Enabled
     Parity Initialization Status: In Progress
     Unique Identifier: 600508B10010443953554B484250000C
     Disk Name: /dev/cciss/c0d1
     Mount Points: /buzonesdir 1.8 TB
     OS Status: LOCKED
     Logical Drive Label: A0C36F2EP61620D9SUKHBPA42A

[...]

At that moment, trying to speed up the parity initialization, I increased the rebuild and expand priority from "medium" to "high".

But, one week later (working with high priority) the "Parity Initialization Status" is still "In Progress".

Do you know if this is normal and I should let It continue working?
Do you know any way to check if really "Parity initialization" is being done and how long It will last?

Thank you very much.